iFlight The Force 5.8GHz PIT/25/200/600mW

Multirotors → FPV Racing drones → FPV drone electronics → Racing Drone Video TX → 200~600mW VTX → iFlight The Force 5.8GHz PIT/25/200/600mW

iFlight the Force 5.8G 48CH 0/25/100/200/400/600mW Switchable FPV Transmitter，support OSD Frequency and Power tuning, The output power is stable, the far transmission distance：≥0.5km@25mW, ≥1km@200mW, ≥2km@600mW;

Protocol: IRC Tramp

Features:

- Support OSD Frequency and Power tuning;
- The output power is stable, the far transmission distance：≥0.5km@25mW, ≥1km@200mW, ≥2km@600mW;
- Transmit power 6 gear switch: 0mW/25mW/100mW/200mW/400mW/600mW;
- Output 48 frequency points, and has E group 8 race frequency at the same time using each other without interference;
- Frequency lock fast, the boot does not interfere with companions;
- Built-in output power self-check function;
- Full format video format：NTSC /PAL;
- Wide input voltage range. low power consumption; 7V～24V，+12V/260mA@600mW;
- Small volume: 36mm×36mm×5mm; mounting holes correspond exactly CC3D NAZE32 F3 F4 Flying control
- Lightweight: 4.3g(Does not contain antenna)

Description:

-Input voltage: 7-24V DC

-Channel: 48

-Power transmission: 0mW / 25mW / 200mW / 400mW /600mW

-Size (mm): 36*36mm

-Weight: 4.3g(Does not contain antenna)

-Connector type: MMCX Connector

Smart Audio - OSD Frequency and Power tuning:
Power the Force VTX by 7-24V, Connect the RX port on VTX to FC. Let's take iFlight REVO Bee F4 as an example, RX port on VTX connect to RX port on FC, Video IN on VTX connect to Video Out on FC. Bind Radio control to the receiver, receiver connect to FC finish setting and control via radio control, and open Betaflight, choose UART6 in Port configuration on Betaflight, IRC Tramp on Peripherals position, click save.

And now, connection and debug on Betaflight is finished. Now you can debug via radio control, pull the throttle to middle, Yaw to far left, Pitch to top, and now there will be debugging interface popup, Pitch up/down as choose, Yaw left-right as confirm and quit, you can set PID, OSD, Frequency and channel, VTX power, after finishing setting you can quit and fly.

Package included:

- 1pc x The Force 5.8GHz PIT/25mw/200mw/600mw VTX
- 1pc x 1.25T 5Pin connecting cable
- 1pc x MMCX-SMA pigtail cable
- 1pc x MMCX Transmitting Antenna

- 1pc x Instruction

Prices for iFlight The Force 5.8GHz PIT/25/200/600mW in stores

Deals found: 24 ()

Racing Drone Video TX

iFlight The Force 5.8GHz PIT/25/200/600mW

Prices for iFlight The Force 5.8GHz PIT/25/200/600mW in stores

See also